eliztech.com logo
Sitemap
Remote Controls > Comcast older models

Programming instructions for older Comcast remote controls

Comcast remote - Silver with red OK button

Programming instructions for older Xfinity/Comcast remotes such as RC1475501/M2057/M1067 (Silver with gray OK button), RC1475505/RC1475507/​1167ABC1/​1067CBC4/MUG1067 (Silver with red OK button) and RC2392101/​MUG3067 (Digital Transport Adapter).

Search for the codes supported by your remote model here.

Direct code entry

Step 1: Press a device key once (i.e., "AUX" or "TV"). When programming the single device Digital Adapter Remote, skip this step.

Step 2: Press and hold "SETUP"/"SET" until the selected mode key/LED indicator light blinks twice.

Step 3: Enter the four or five digit code for your device. The selected mode key/LED indicator light will blink twice.

Step 4: Aim the remote control at your device and press "Power" once. The device should turn off. If it does not respond, repeat the procedure trying each code listed for your brand until you find one that works.

Notes:

  • If you enter an invalid code, the LED will emit one long blink and the remote exits programming mode.
  • Use the "AUX" key to program control of an Audio Amplifier or Receiver, a DVD Player, a HomeTheater-In-A-Box Device, a PVR/DVR, or a VCR.
  • To program the T01 Tracer RF4CE and Xfinity-Spectrum X1 remotes, press and hold the "DEL"/"Delete" key until the green light under the "Power" button blinks twice in step 1. The rest of the procedure is the same.
 

Code search

If you can't find a working code for your device, follow the steps below:

Step 1: Turn on your device.

Step 2: Press a device key once (i.e., "AUX" or "TV"). When programming the single device Digital Adapter Remote, skip this step.

Step 3: Press and hold "SETUP"/"SET" until the selected mode key/LED indicator light blinks twice

Step 4: Enter 9 9 1. The the selected mode key/LED indicator light will blink twice.

Step 5:

v.1 (Silver with gray OK button): Aim the remote control at the the TV and slowly alternate between pressing "Power" and the device button (i.e., "TV"), until the device turns off.

v.2 (Silver with red OK button): Press "1" to search for a TV code; "2" for DVD/VCR; "3" for an audio device. The LED will flash twice. Press the "Power" button, then press "CH+" multiple times until the device turns off.

v.3 (Digital Transport Adapter Remote): Press "CH+" multiple times until the device turns off.


Step 6: Press "SETUP"/"SET" once to lock in the code. The selected mode key/LED indicator light will blink twice.