Programming instructions for Charter Spectrum remotes using 3 digit codes: UR5U-8780L/8790L, UR3-SR3M/SR3S, UR5U-8720L, UR5U-8820L, UR2L-R803, UR2L-R803, UR3-SR/SR2, UR4U-MDVR-CHD2, UR5-8400, UR5-8400A, UR2-DTA-TWC2 and other similar models.
See also: code lists and programming instructions for Spectrum remotes using different 3 digit (v2) codes, 4 digit codes and 5 digit codes.
Step 1: Turn on the equipment that you want to control (TV, DVD, Cable Box, Soundbar, etc.).
Step 2: Press the device button ("TV", "DVD", "CBL", "AUX", etc.) and the "OK/SEL" button simultaneously for 3 seconds. The corresponding device LED will turn on indicating that it is ready to be programmed. The LED will remain on for 20-30 seconds. The next step must be entered while the LED is on.
Step 3: Point the remote control toward the equipment and enter the 3 digit code assigned to your brand. If there is more than one 3 digit number listed for your brand, try one code number at a time until your equipment turns off.
Step 4: Store the code by pressing the same device button you pressed in Step 2 once again. The device LED will blink twice to confirm that the code has been stored.
Note:
If none of the 3 digit codes assigned to your brand of equipment works or the code table does not list your brand, you can try the following:
Step 1: Turn on the equipment that you want to control (TV, DVD, Cable Box, Soundbar, etc.).
Step 2: Press the device button ("TV", "DVD", "CBL", "AUX", etc.) and the "OK/SEL" button simultaneously for 3 seconds. The corresponding device LED will turn on indicating that it is ready to be programmed. The LED will remain on for 20-30 seconds. The next step must be entered while the LED is on.
Step 3: Press the "CH+" or "CH-" button one at a time or keep it pressed. The remote will emit a series of Power ON/OFF code signals. Release the "CH+" or "CH-" button as soon as your equipment turns off.
Step 4: Store the 3-digit code by pressing the same device button you pressed in Step 2 once again. The device LED will blink twice to confirm that the code has been stored.
Note:
Step 1: Press the appropriate device and the "OK/SEL" buttons simultaneously for 3 seconds. The device LED will turn on for 20-30 seconds. The next step must be performed while the LED is on.
Step 2: Press the "INFO" button. The device LED will blink a number of times indicating the number of each digit for the code. Each digit is separated by a one second interval of the LED being off.
Example:
One blink, (pause) three blinks, (pause) eight blinks indicates the code number 138. Note: Ten blinks indicates the number 0.
GE universal remotes
RCA universal remotes
Philips universal remotes
AT&T U-verse remotes
DirecTV remote controls
Comcast remote controls
Verizon Fios remotes
Cox remote controls
Altice remote controls
Dish Network remotes
OneForAll remote controls